Page 2
RPK5-GM4101
Complete Radio Replacement Kit with
Integrated Climate Control Retention for
2010-2015 Chevrolet Camaro
PAC
®
| 866-931-8021 | [email protected]
©2016 Pacific Accessory Corporation
www.pac-audio.com
Rev. 113016
Pacific Accessory Corporation
PAC is an AAMP power brand
Disassembly of the factory HVAC control panel
The following steps will aide you in the disassembly of the HVAC control panel so that the factory
HVAC control knobs and supports can be reused in the PAC RPK5-GM4101 Integrated Kit.
2.6 - Be sure to keep the screws
separated as there are different lengths
and diameters.
2.5 - Using a flat bladed pry tool remove two
of the white fasteners off of the black plastic
backing.
2.4 - Remove the 10 Phillips head screws
shown below and remove the black plastic
backing.
2.2 - Pry outwards on the clips on either side
of the plastic trim that surrounds the white
connector.
2.3 - Once the plastic trim is removed, locate
the 16 pin connector shown below. Using a
flat bladed tool, press in the grooves on both
sides, pry upward and away from the circuit
board, to release the connector.
2.1 - Remove the 2 Phillips head screws
shown below.
1.3 - Remove the 4 x 7mm bolts (1) securing the radio
(2) into the dash. Slide the radio (2) to the rear and
disconnect all electrical connections.
You can set the radio aside as it will not be used fur-
ther. For the next section, you will be working with
the factory HVAC control panel to utilize the HVAC
knobs allowing for more of a factory experience
when using the PAC RPK5-GM4101.
Proceed to the next section to begin disassembly of
the factory radio control assembly.
Removing the factory radio from the vehicle (cont.)
