Complete Radio Replacement Kit with
Integrated Climate Control Retention for
2003-2007 Honda Accord
RPK4-HD1101
P
ifi A
C
ti
Page 4
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Rev: V8
Date: 081318
Illustration / Schematic
Dual Zone
Climate Controls
DIP Switches
To KIT Display
To OEM
Upper Display
Single Zone
Climate Controls
USB
To Aftermarket
Radio Harness
St
eering Wheel
C
o
ntr
ol Outputs
Na
vigation
Outputs
To Vehicle’s
Radio Connector
To Aftermarket
Radio
(see connection
chart above)
Navigation SWC Input
(passenger kick panel)
Data Input
(driver kick panel)
Aftermarket Radio Connections
Yellow
B12v
Black
Ground
Red
Accessory Output
White
Front Left + input
White / Black
Front Left - input
Grey
Front Right + input
Grey / Black
Front Right - input
Green
Rear Left + input
Green / Black
Rear Left - input
Purple
Rear Right + input
Purple / Black
Rear Right - input
Blue
Amp Remote Turn On
Light Green
Parking Brake
Pink
Vehicle Speed Output
Orange
Illumination Output (+)
Purple / White
Reverse Output (+)
* This wire is longer than the others and will need to be
run to the kick panel area. See below for more
information.
White / Black*
Navigation SWC Input
Pink / Black*
Data Input
Blue / Yellow
(SWC Output)
Kenwood or Newer JVC
3.5mm Jack
(SWC) Output
Alpine, JVC, Clarion,
Pioneer, Sony, Boyo, Dual,
Lightning Audio, Visteon,
Jensen or Advent
Route the Pink / Black wire from the RPK4-
HD1101’s vehicle harness down to the driver
side kick panel. Connect the Pink / Black
wire to the Brown / Yellow wire located in the
45-pin white connector located above the
fuse panel. It will be necessary to remove
the under dash panel if equipped.
Route the White / Black wire from the RPK4-
HD1101’s vehicle harness down to the
passenger side kick panel. Connect the White
/ Black wire to the Gray wire located in the
6-pin blue connector. Disconnect the 14-pin
green connector from the navigation module
located in the trunk area.
Connecting the Pink / Black wire
Connecting the White / Black wire
Note: This wire is only needed when the vehicle is equipped with single
zone HVAC controls. See page 6 if you are unclear as to which HVAC
system is in your vehicle.
Note: This wire is only needed when the vehicle is equipped with the
factory navigation system and when the supporting “Voice” and “Back”
steering wheel controls are present.
Note:
)RUSURSHURSHUDWLRQFRQ¿UP
that the connectors are connected into
the proper openings. Failure to verify
will cause the HVAC kit to function
incorrectly. Reference the the sticker on
WKHEDFNRIWKHPRGXOHIRUFODUL¿FDWLRQ
