PABX CS208, Руководство пользователя

Страница: 10 / 37

Chap
Chap
Chap Chap 3
3
3 3 System
System
System System programming
programming
programming programming
3.1
3.1 3.1
3.1 Before
Before Before
Before programming
programming programming
programming
● All the programming must be carried out on the extension 601, 602, 603, 604; all the
programming must be into system programming status.
● All the extensions must be of dual tone multi-frequency phone.
● You are allowed to operate one by one, and end the process by simply pressing #. You
don’t have to hang up if something wrong occurs, you could press * to restart.
● If programming-extension (601,602,603,604) is in Direct-Dialing-Out mode, you need to
press * to enter the internal system, then start programming.
●
When the setting is finished, a long beep indicates that the setting is done correctly and
saved in the system. If instead an array of short chirps is heard, that would indicate an error
occurred in the setting. You need to check it out and reset the system. It is only after the end
of the long beeps you can continue another system operation.
● You must use “enable C.O. lines” command according the actual trunk lines before using
this product, if you don’t enable any C.O. line, the system will consider there is no C.O. line
and doesn’t auto detect C.O. line.
How to programming
At first you must according 3.2.1 instruction enter into system programming status, and then
you can begin to program as the following instruction.
3.2
3.2 3.2
3.2 Basic
Basic Basic
Basic Command
Command Command
Command
3.2.1 3.2.1 3.2.1 3.2.1 Enter Enter Enter Enter into into into into S S S Sy y y ystem stem stem stem Programming Programming Programming Programming S S S Sttttatus atus atus atus
Format: # * EFGH
Explanation: EFGH is the system password now.
Example: For programming the system, you should enter the password first, now the
password is 5678
P9