QSM-6505A Manual
- 7 -
Aux Connection (Input)
The equipment provides 4 auxiliary input which may be used for connecting other signal
sources such as a Radio Tuner, CD or Cassette player. A slide switch is located near by
AUX1/MIC 2 on the rear panel for selection of Mic2 or Aux1. Aux 2 ~ 4 inputs are a dual
RCA jack and has a stereo to mono converter for each channel
SLEEVE
PIN
RCA plug connector
High Level Input Connection
The “High Level” terminal is for connecting the signal sources from other amplifier output,
which is normally connected to the speaker.
Output Connection
There are 5 output terminals on the rear panel. Each terminal has 3 speaker outputs: 8
ohm, 70V and 100V. Use only one of these outputs for connection.
7. Operation
After all connections are completed, turn the Input Source Selection Switch of each channel
to set on the corresponding position for the signal source. If necessary, turn the bass, treble,
and volume control to what you desire.
Before using the microphone 1 on the front panel to broadcast, make sure the level (volume)
control of MIC 1 is at proper position (not at maximum position). Set the push switch of
each channel to control the mute function of its own channel signal source. Switch-down is
to mute signal source, only the voice from MIC 1 can be heard, while switch-up does not
mute signal source, both voice from MIC 1 and channel signal can be heard. If necessary
to adjust the volume further, turn the level control of MIC 1 and/or of Channel 1 ~ 5.
