- 3 -
Mounting (see diagram):
A.
Use the included screws or other hardware to mount the
base plate to a suitable mounting surface.
You can attach the plate to a fencepost, structure, tree, etc.
Be certain not to pierce any plumbing or electrical
equipment when you mount the base plate.
Mount the base plate with the screw holes vertical. The
Deerchaser™ unit is designed to mount to the base plate
vertically. We do not recommend mounting the unit
horizontally. The sensor will not work properly.
Choose your mounting location carefully. The base plate
allows you to adjust the angle of the Deerchaser™ up or
down. We suggest mounting the unit high enough that it is
out of the reach of children. You can adjust the angle of the
base plate down to protect the intended area.
B.
Attach unit to base plate by sliding mounting clip into
matching slot on rear of unit. Then slide unit down on the
clip until it is fully engaged. Be sure clip is fully inserted in
slot.
C.
Rotate unit up and down to reach desired mounting
angle. Base plate does not rotate from left to right, only up
and down. PIR motion sensor has a wide angle of
detection. Typically side to side adjustment is not
necessary.
Aim the Passive Infra-red motion detector (PIR) lens
towards the protected area. The PIR features a range of
approximately 25 feet at an angle of 110° (see diagram). If
possible, aim the sensor at an area with fewer branches
and/or vines. Branches moved by strong breezes may
trigger the motion detector circuit. This is normal but should
be minimized to extend battery life.
The Loudspeaker and LED lamp have a longer range than
the PIR. Once the signal is activated, the protected area will
be larger than the PIR range.
PIR RANGE DIAGRAM
B
C
A
A
MOUNTING THE DEERCHASER™ (SIDE)
Advice:
Choose a strong local FM signal if possible. FM reception
conditions will vary with time of day and weather conditions.
When possible choose your FM signal during the day.
Typically reception is weaker during the day.
Choose an FM broadcast signal featuring “talk radio” or
news broadcasts if possible. Experiment with different FM
broadcasts and observe results.
Use the maximum volume level possible in your application.
Louder signals will be more effective.
When possible, mount the unit under cover. While the unit
is weather resistant, shield it from direct sunlight and rain
when possible.
If possible, aim the PIR motion sensor at an area with fewer
branches and/or vines. Branches moved by strong breezes
may trigger the motion detector circuit. This is normal but
should be minimized to extend battery life.
