- 2 -
Control Legend (see diagram):
Remove thumbscrew on rear of unit to access
battery/control compartment.
1.
Battery compartment: Insert 3X “D” cell alkaline or lithium
batteries. Be sure to follow the polarity diagram and insert
the batteries correctly. Do not mix old and new batteries.
2.
SENS: Adjust the sensitivity of the PIR motion detector.
Typically leave it set at maximum (fully clockwise). To
reduce the coverage area rotate the control counter-
clockwise.
3.
Time: Adjust the duration of the Deerchaser™ signal.
Adjust from a minimum of approximately 15 seconds to a
maximum of approximately 7 minutes. After the set time, the
Deerchaser™ will reset and await the next activation.
4.
RESET: Restart automatic radio tuning from the lowest
FM frequency (88.3 MHz).
5.
Volume: Rotate the knob down to increase the volume of
the Deerchaser™ signal. Typically leave it at maximum
volume to increase effectiveness. If necessary rotate the
knob up to reduce the volume. Rotate the knob all the way
up until it clicks to turn off the unit.
6.
TUNNG: Advance automatic radio tuning to the next
received FM frequency. When you have reached the end of
the FM tuning band (107.9 MHz) you will note the received
signal will no longer change. Press the RESET button to
restart tuning at the lowest frequency.
Use:
Remove thumbscrew on rear of unit to access
battery/control compartment.
Insert 3X D cell batteries. Insure correct polarity by following
the diagram. Use only new high-quality alkaline or lithium
cells. Rechargeable batteries are not recommended.
Dispose of exhausted batteries properly.
Rotate the volume control (Volume) downwards to turn on
the unit.
If necessary, wave your hand in front of the PIR lens to
activate the unit.
Press the tuning button (TUNNG) to automatically scan the
FM tuning band to receive an appropriate strong FM
broadcast signal. Repeatedly press the tuning button to
choose your station. Press the reset button (RESET) to
reset the tuning to the lowest frequency. Test reception by
setting unit down and removing your hands. When the unit
is close to your body, tuning sensitivity can change.
Time
SENS
Volume TUNNG
RESET
1.5V/"D" SIZE -
+
1.5V/"D" SIZE
-
+
1.5V/"D" SIZE -
+
1
2
3
6
5
4
BATTERY/CONTROL COMPARTMENT
Rotate the time duration control (Time) to the desired
setting. Shorter durations will extend battery life while
longer durations will have more effect on persistent pests.
Experiment with this setting for best results.
Rotate the sensitivity (SENS) control to the desired setting.
Typically leave it set at maximum (fully clockwise).
Re-install battery door and secure with thumbscrew. Insure
the battery door is fully seated around the entire panel.
Insure thumbscrew is tight to insure weather resistance. Do
not over tighten.
