P1PE P5200MT, Руководство пользователя

Страница: 19 / 32

6.2. Engine - Warm start.
6.2.1. Fill the machine with fuel as described in section 5.
6.2.2. Turn the power switch (1) to the on position (
I
).
6.2.3. Set the machine on a firm and flat surface.
6.2.4. Move the choke lever (5) to the lower (open)
position.
6.2.5. Pull the starter rope (4) with a short stroke out until resistance is felt (about
100mm). Then pull firmly and continuously, do not let go of the starter handle
instead let it return slowly.
6.2.6. Before starting work allow the engine to warm up at idle speed for about
ten minutes.
6.2.7. If engine does not start then follow the Engine - Cold start section.
6.2.8. Never leave the machine unattended.
6.3. Stopping the machine.
6.3.1. Release the throttle lever and let engine idle.
6.3.2. Press the start-stop switch on the handle to off position (
O
) and wait until
the machine stops.
6.3.3. Never leave the machine unattended.
6.4. Trimming techniques.
If you are not familiar with the trimming, practice with the
machine In the off position (
O
) (switched off), as shown below.
6.4.1. Always trim or cut with high engine speeds.
6.4.2. Do not run the machine slowly.
6.4.3. Swing the nylon cutting head of the trimmer horizontally from one side to
the other.
6.4.4. Keep cutting deck parallel with the ground. Do not tilt the nylon cutting
head during operation.
6.4.5. For correct cutting height trim in advance in a test area.
6.4.6. Keep nylon cutting head at the same level for even depth of cut.
19