P-Tronic 40P, Инструкция по эксплуатации, Страница: 15 / 30

GB
En
gl
is
h
Instruction Manual
P-Tronic 40P - 70 - 100
11.1 Standard Stand Off in Solid Cutting
This is the typical and most commun cutting type; you can adjust the current from a minimum of 20A to a maximum of 100A. Once the cutting is terminated the arc strikes off and it can
be reactivated pressing the torch trigger once again. Use always the spacer (11) unless you have particular precision needs as described in “GRATING” paragraph.
The solid cutting can be performed in three modes:
A) Contact, precison cutting without using the spacer
B) Standard stand off for a current up to 70A
C) Standard stand off for a current higher than 70A
A) Contact precision cutting
Use Code
3 electrode Z0060AA
4 gas diffuser Z0061AA
6 cutting tip 0,9 Z0063AA
9 outer nozzle
Z0070AA
P-Tronic 100
B) Standard stand off for current up to 70A
Use Code
3 electrode Z0060AA
4 gas diffuser Z0061AA
9 outer nozzle Z0070AA
11 double pointed spacer Z0072AA for current 40 ÷ 50 A
7 tip cutting 1,0 Z0064AA for current 40 ÷ 50A
7 tip cutting 1,1 Z0065AA for current 50 ÷ 60A
7 tip cutting 1,2 Z0066AA for current 60 ÷ 70A
C) Standard stand off for current 70A - 100A
Use Code
3 electrode Z0060AA
5 gas diffuser Z0062AA
10 outer nozzle Z0071AA
11 double pointed spacer Z0072AA
8 tip cutting 1,4 Z0067AA for current 80 ÷ 90A
8 tip cutting 1,5 Z0068AA for current 100 ÷ 110A
8 tip cutting 1,6 Z0069AA for current 110 ÷ 120A
Note: the current must be set less than 40A, it is suggested the grating set.
Note: the spare parts are the same if the straight automatic
torch is used.
P-Tronic 100
P-Tronic 100
P-Tronic 100
- 11 -