P-Tronic 40P, Инструкция по эксплуатации, Страница: 10 / 30

GB
En
gl
is
h
Instruction Manual
P-Tronic 40P - 70 - 100
Step 4:
The reducer has an “IN” nipple that has
to be connected to the compressed air
net and an “OUT” nipple: provide an 8x6
teflon tube of about 30 cm to link the out-
put nipple “OUT” with the machine air in-
put nipple positioned on the back of the
machine.
Step 3:
Put the hanger on the handle back
side and fix the reducer using the
proper ring nut
2
3
5
1
4
6
IN nipple
Supply Cable
Air Input
Filter/Reducer
OUT nipple
Teflon
tube
E) Press the torch trigger: the pilot arc stricks, becoming cutting arc as
soon as you will place the torch on the work
piece. The P-TRONIC 40 generator does
not work with high-frequency arc ignition:
it uses the no HF technology with BACK
STRIKING system. The torch can work only
if the generator is connected to the com-
pressed air plant
F) The pilot arc stops automatically after about 5 seconds if you do not place
the torch on the work piece
G) Check the manometer value and adjust eventually the air pressure
H) Once the cutting process is terminated release the torch trigger: the air
flow will continue to allow the cooling down of the torch
Warning: never aim the plasma jet towards people or
foreign objects !
6.2 Use of the equipement:
A) Connect the earth clamp cable to the work piece
B) Connect the machine to the power supply net and turn ON the power
switch (position 2. page. 5); the ON/OFF led (position 5 page. 5) light on
C) Check the air pressure on the manometer as indicated in the previous
paragraph
D) Set the current value with the knob (1st position fig. pag. 5) according to
the work piece tickness
According to the cutting type and mode, the torch must be equipped with suitable
spare parts. The P-Tronic 40 generator enables either the contact or stand-off
cutting.If you have to make a precision cut on sheet metal and when the spacer (8)
cannot be used, we recommand the Tip 0,9 (5) code Z0050AA. In case of spacer/
stand off cutting, use the Tip 1,0 (6) code Z0051AA.
- 6 -
P-Tronic 40P