8
MAN 9061374 EN V2
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tlf: 70212626
DK-6600 Vejen
e-mail: [email protected]
Starting and operating the machine
Start the engine at halt throttle and let it warm up for about 3 minutes
.
Then put the engine on full throttle.
(fig
.
9
,
10)
Put the branches in the input tube and when you feel they are pulled in by
the rotating blades
,
let the branch go
.
Do not hang on to the branch
,
the
branch will be pulled in by the machine by itself. Side branches with a
diameter exceeding 3 cm should be sawn or cut off and shredded
separately.
Warning!
In case of emergency or any doubt
,
immediately activate the safety switch (red
knob) to be found by the engine.
(fig
.
11)
Before starting the engine check that the bolts holding the input and output tubes
are fully tightened
.
(fig
.
12
,
13).
IMPORTANT!
If the safety switch on the input pipe has been activated, it must be reset by
pulling the button out again, as shown in the photo below:
