5
MAN 9018936 EN V2
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70 21 26 26
DK-6600 Vejen
e-mail: [email protected]
D
Slide the bearing on the drum shaft on the engine
side and secure it with the spiral ring Ø 42 mm.
Carefully place the lower part of the drum on the
frame. Make sure that the bearing slides down into
the frame. Put the connecting rod cap on (opposite
the engine side) and tighten loosely. Insert the bolts
into the bearing on the engine side. It may be
necessary to insert a screwdriver to center the holes.
Tighten all the bolts.
E
Turn the drum with the opening at the top and
loosely insert the mixer blades. Note the direction
of rotation (arrows on the drum).
If in doubt, put the top of the drum on loosely.
Make sure you mount fibreboards between the
bolts that hold the blades in place so that water
does not drain out.
F
Fit the upper part of the drum by placing
the 2 parts above each other right by the
bolt holes and the mixer blades.
