SPECIFICATION / REPLACEMENT PARTS
GLUEBOARD REPLACEMENT
GLUEBOARD REPLACEMENT SHOULD BE CARRIED OUT BY SERVICE PERSONNEL ONLY, AFTER
ENSURING THAT THE UNIT IS DISCONNECTED FROM THE MAINS SUPPLY.
The glueboard should be replaced every month with a genuine glupac
®
glueboard. Use of
non-approved glueboards may invalidate your guarantee.
To replace the glueboard…
1. Remove the used glupac
®
glueboard by simply sliding it out of the top of
the front guard and either retain for insect evaluation or dispose of it hygienically.
2. Remove the protective release paper from the new glupac
®
glueboard.
3. Slowly slide the new glueboard into position with the adhesive side facing the tube.
Always ensure the selected genuine glupac
®
glueboards are compatible with your unit, available
from your pest control operator or P+L Systems Ltd.
TUBE REPLACEMENT
TUBE REPLACEMENT SHOULD BE CARRIED OUT BY SERVICE PERSONNEL ONLY, AFTER ENSURING THAT
THE UNIT IS DISCONNECTED FROM THE MAINS SUPPLY.
To ensure the efficiency of Uplighter
TM
in catching flying insects, the UV tube should be replaced
annually. After twelve months the phosphor coating that emits the correct wavelength of UV light
has burnt away and the UV output is diminished substantially.
To replace the UV tube...
1.
Rotate the tube through 90 degrees.
2. Gently pull the tube away from the unit.
3. Dispose of the used UV tube in conjunction with local WEEE regulations.
STARTER REPLACEMENT
BEFORE REPLACING THE STARTER, ALWAYS ENSURE THAT THE UNIT IS DISCONNECTED FROM THE
MAINS SUPPLY.
The starter provides an extra spark to initially light the UV tube. Starters wear out and should be
replaced at the same intervals as the UV tube.
To replace the starter…
1. Rotate the starter anti-clockwise.
2. Pull the starter free from the unit.
3. Insert the replacement starter and reverse steps one and two.
Unit
Uplighter
Voltage
230V ~ 50Hz
Dimensions(mm) 530 X 190 X 153
Coverage
30 Sq. Metres
Weight
2.9 Kg
Light Output
15W
Tube
1 x TGX15-18
Starter
i154
Glueboards
6171 (Black)
Tube Replacement
Starter Replacement
Glueboard Replacement
R2 05/14
C
2014
P+L Systems Ltd
Information provided on these instructions is modified and
updated from time to time. This is due to the constant
redevelopment of our products. As such, it is not intended that
you should rely on it or that it should form part of any contract.
Sterling House
Grimbald Crag Close
Knaresborough
North Yorkshire
HG5 8PJ UK
T +44 (0)800 988 5359
F +44 (0)1423 863 497
W www.pandlsystems.com
E [email protected]
WEEE Compliance No. WEE/
