Glueboard Replacement
Tube Replacement
GLUEBOARD REPLACEMENT
GLUEBOARD REPLACEMENT SHOULD BE CARRIED OUT BY SERVICE PERSONNEL ONLY, AFTER
ENSURING THAT THE UNIT IS DISCONNECTED FROM THE MAINS SUPPLY.
The glueboard should be replaced every month with a genuine glupac
®
glueboard. Use of
non-approved glueboards may invalidate your guarantee.
To replace the glueboard…
1.
Position
Flypod
®
so the back is facing you.
2. Using one hand to support the unit, use your thumb and forefinger of your other hand
to gently pull the used glueboard out through the slot in the back of the unit.
3. Once free from the unit, dispose of the used glueboard hygienically.
4. Remove the protective release paper from the new glupac
®
glueboard.
5. Slowly slide the new glueboard into position along the two runners with
the adhesive side facing the tube.
Always ensure the selected genuine glupac
®
glueboards are compatible with your unit, available
from your pest control operator or P+L Systems Ltd.
TUBE REPLACEMENT
TUBE REPLACEMENT SHOULD BE CARRIED OUT BY SERVICE PERSONNEL ONLY, AFTER ENSURING THAT
THE UNIT IS DISCONNECTED FROM THE MAINS SUPPLY.
To ensure the efficiency of Flypod
®
in catching flying insects, the UV tube should be replaced
annually. After twelve months the phosphor coating that emits the correct wavelength of UV light
has burnt away and the UV output is diminished substantially.
To replace the UV tube...
1. Pull the tube gently from the tube holder until it un-clips.
2. Dispose of the used UV tube in conjunction with local WEEE regulations.
STARTER REPLACEMENT
STARTER REPLACEMENT SHOULD BE CARRIED OUT BY SERVICE PERSONNEL ONLY, AFTER ENSURING
THAT THE UNIT IS DISCONNECTED FROM THE MAINS SUPPLY.
The starter provides an extra spark to initially light the UV tube. Starters wear out and should be
replaced at the same intervals as the UV tube.
To replace the starter…
1. Remove the glueboard from the units described above.
2. Rotate the starter anti-clockwise.
3. Pull the starter free from the unit.
Unit
Flypod
Voltage
230V - 50Hz
Dimensions (mm)
200 x 310 x 170
Coverage 30
Sq. Meters
Weight
1.5kg
Light Output
18W
Tubes
1 x TPX18
Starter
1 x I154
Glueboard (x6)
INF252 (White)
SPECIFICATION / REPLACEMENT PARTS
Starter Replacement
R4 03/14
C
2014
P+L Systems Ltd
Information provided on these instructions is modified and
updated from time to time. This is due to the constant
redevelopment of our products. As such, it is not intended that
you should rely on it or that it should form part of any contract.
Sterling House
Grimbald Crag Close
Knaresborough
North Yorkshire
HG5 8PJ UK
T +44 (0)800 988 5359
F +44 (0)1423 863 497
W www.pandlsystems.com
E [email protected]
WEEE Compliance No. WEE/GF0661QR
