P.I.T. PST20H-15, Руководство пользователя, Страница: 8 / 24

Cordless Stapler
7
Model PST20H-15/1013A
Compatible charger
(availability varies by
package)
PH20-2.4 A
PH20-3.0 A
Note
Since the product is constantly being im-
proved, P.I.T. reserves the right to make
changes to the specifications and product
specifi cations specifi ed here without prior no-
tice.
Delivery set
Model PST20H-15/1013A
Cordless stapler 1 pc
Battery (2Ah) -
Charger -
Staples 500 pcs
Nails 500 pcs
Hex wrench 1 pc
User’s Manual 1 pc
USE
Loading staples/nails
► tilt the tool or lay the tool fl at, so the sta-
ples or nails will not drop out while loading.
► press lever A while pulling slider B back-
wards.
► place the nail strip into magazine C (maxi-
mal capacity 90 nails).
► push slider B against tacker head D until it
snaplocks.
Attention
Make sure that
► the staple strip is loaded with the crown
aligning with the top line of the magazine C.
► the nail strip is loaded with the tapered end
aligning with the bottom line of the maga-
zine C, so the brad nail head rest right into
the grooves which corresponds with the
symbol of nail length on tacker head D.
► push slider B against tacker head D until it
snaplocks.
Operating the tool
► firmly press tacker head D against the
workpiece until it is pushed in a few milli-
meters, when LED is lighting.
► briefl y press trigger F and then release
again.
► Trigger F is locked as long as you do not
press tacker head D against the work-
piece, thus preventing accidental opera-
tion.
► At 20 shots/min,tacker should be allowed
to cool down after 30 minutes as it is only
rated for short-time duty.
► remove all staples/nails from the maga-
zine after each use.
Impact control
With knob G the required impact level can be
adjusted in steps
► indicator G shows the selected impact lev-
el.
► “-” for thin and light materials such as foils
and fabrics.
► “+” for thick and tough materials such as
hard woods and walls.
► before starting a job, fi nd the optimal im-
pact level by testing out on spare material.
Application advice
► Fastening panels.
► Do not use the tool for fastening ceiling
panelling on profi led wood or grooves.
► Fixing textiles.
► Avoid blank shots in order to reduce the
wear of the impact strike.
Nail instructions for tackers
► Rougly, the hardness of wood is divid-
ed into 3 levels:
- High
- Medium
- Low
► Nails of diff erent length are applicable for
diff erent wood hardness.
► The tool has a recoil when firing, so two
hands operation is suggested, to have a
better control of the operation.
Unblocking jammed fasteners
► In the unlikely event that nails become
jammed, follow these instructions to re-
move them.
► unplug BATTERY PACKAGE before re-
moving.
- tilt the tool or lay the tool fl at, so the sta-
ples or nails will not drop out while loading.
- press lever A while pulling slider B back-
wards.
- take the jammed nail out magazine C.
Battery pack
► The tool uses an 20V battery pack, when
ordering replacement battery packs, be
sure to include catalogue number and volt-
age.
To install the battery pack
► Line up the guide slots on the battery and
on the base of the tool. Slide the battery
pack firmly into place until you hear the
lock snap into place as shown in picture
above.
► To remove the battery pack from the tool,
press the release button and firmly slide