Page | 9
Save – Allows saving of the current parameters to a file in a storage location such as the computer
hard drive.
Store – Allows storing of the current parameters to a preset location on the amplifier. Locations are
provided to the user to enable this, and avoid writing over any factory presets. Once a preset is
overwritten, the original preset file must be used to recover the data.
Recall – Loads a preset from the amplifier memory, remotely. This allows presets to be changed on
units in inaccessible locations. However, once the COM cable is removed, the unit will revert back to
the preset as indicated by the knob on the unit itself.
Setup – This is largely a factory operation to switch the amplifier from two-way to bridged mode.
This is not required by the user unless some drastic last minute servicing is required.
From the parameters page, the following parameters can be adjusted:
Noise Gate – Allows the user to cut out background noise when the device is not in use. This can be
especially useful when a lot of open microphones are picking up crowd noise, or making a stage very
noisy.
Input Source – Allows the user to select between a noise source and the analog input. The noise
source is especially useful when tuning the system to a particular room, or for fault finding.
Noise Generator – Provides level control and noise type when noise generator is selected as the
input.
Phase – Polarity switching is allowed with the option of 0 or 180 degrees.
Delay – Delay can be specified in both time and distance.
DLF – DLF is a set of filters tuned specifically to make recorded music sound more dynamic at low
levels. In the ‘music’ presets on the amplifier, this option is turned on.
High Pass Filter – All of the cabinets already have a high pass filter programmed in, but an extra high
pass filter is provided to the user for crossover, or extra subsonic filtering.
5 Band Parametric EQ – Q factors up to 10 are available to give the user complete control over the
sound of their system.
Mute – Separate mute controls are available for both low and high frequency output channels.
Passwords:
OUTPUT = for editing parameters in detail
LIMCMP = to adjust clip limiter settings. This is not saved in the preset file.
