P.A. SRWD-1,2, Быстрый старт

Страница: 6 / 12

F o r m X X X X : R e v i s e d A u g u s t , 2 0 1 5 Page 6
application’s combination of:

Mode (unwind or rewind)

Dancer arm location (right or left side of reel)

Coil wrap (under or over)
3.1 Dancer Arm
Install the dancer arm toward the side of your choice through the clamp on the dancer arm shaft extending
from the front panel of the base cabinet. Slide the dancer arm in or out to set the roller at the estimated point
of minimum material slack loop motion. Set the slack loop height by rotating the dancer arm clamp on the
shaft, after first loosening the clamping screws, then retightening.
You may find that the mechanical smoothness of a dancer arm motion (up and down) can be improved by the
setting of dancer arm extension (closer to or further from, the reel) for higher speeds and longer travel feed
lengths. Find the point of minimum loop motion while feeding and place the roller at that point.
While the dancer arm is very light and flexible to reduce the danger of light material being marked by contact
with the roller, further protection is available for extremely delicate material in critical situations.

You may add a small counterbalance to the dancer arm.

You may add a foam rubber sleeve around the roller, provided in attached kit.
The roller has been positioned on the arm so that the inner edge of its cylindrical section is in line with the
inner keeper disc.