OZtrail MPG-GD30C-B, Руководство пользователя

Страница: 17 / 20

a lower half new leg
a complete new let
Either a lower half or complete new Gazebo
leg as indicated in Figure 21 can be replaced.
If it is only the lower part of the leg that is
required this also can also be purchased as a
spare part and comes complete with all
necessary fittings. The lower leg section can
be simply replaced by sliding the broken part
out of the main body of the leg by releasing
the clips that hold the height adjustment in
place. The replacement can then be slid into
the leg and clipped into place. Care needs to
be taken to ensure the holes for the height
adjustment are aligned with the pin.
Tools required (not provided) as indicated in
Figure 20
REPLACING DAMAGED LEG
COMPONENTS
1 x Phillips screwdriver

Figure 20
Figure 21
17
SPARE PARTS AND REPAIR PROCEDURES
1
2
Figure 19
If the pin at the top of the leg that holds the
struts up does not pop out it has probably
moved inside the leg. If this happens, lie the
gazebo on its side and remove the screws
holding it in place (screws also hold the ring
clips for the walls).
This will allow access to the pin via the top of
the leg using a hooked piece of wire to
manoeuvre the sprung clip back into place.
The complete new Gazebo leg comes with all
fittings to allow easy replacement. Remove
the damaged leg as indicated in Figure 22. Be
careful to keep the screws as often these can
be used again. Align the new leg, reinsert the
screws and tension with screwdriver.
All the plastic components for the leg are
available as spare parts.