PLEASE NOTE
IN SEVERE CONDITIONS THE TENT SHOULD BE DISMANTLED.
Step 5 – Erec t the Front awning
Begin by selecting the three horizontal ridge awning poles (6) to attach to the three front elbow poles (7)
under the awning. Insert the tip of the right angle spigot into the hole on the front of the elbow pole(7) and
adjust the pole length to match the length of the awning. Select the centre upright awning pole (9) and with
a friend place the ends of the two diagonal ridge awning poles (5) with holes onto the spigot of the centre
ridge upright (9) (ensure the adjustment screw for the diagonal ridge awning poles are facing down). Position
the spigot of this assembly through the hole in end of the centre awning ridge pole (6) and then through
eyelet in the awning, attach a guy rope and peg down. Ensure peg point is approximately 1.5 – 2m from
pole base. Repeat this procedure for the two corner awning upright poles (4) and side awning ridge poles
(6) while remembering to attach the other end of the diagonal ridge awning poles (5) through the corner
upright spigot.
Attach the guy ropes to the webbing tabs along each side of the awning roof.
Tension all adjustable poles and guy ropes so the roof sits taut and will not hold water.
WARNING
If the awning is not tensioned correctly, water will pond and may cause damage to the fabric and poles.
This damage is not covered by warranty.
Step 6 – Erec t the side awning
Open side entrances as required.
to erect awnings select awning poles (8) and position top of pole through eyelet in awning. Attach guy rope
to top of pole and peg down. It is recommended awnings are lowered during heavy rain.
Step 7 – Install room divider
The divider has toggles on the edges which attach to the fabric loops inside the tent. To install the curtain,
push each toggle through its corresponding loop inside the tent.
