background image

ASSEMBLY INSTRUCTIONS : 

IMPORTANT: This tent is to be pitched once before going camping to ensure 
that all parts are present and to become familiar with the assembly of the tent.

Step 1 - Lay out the tent

Select a sheltered camp site protected from the wind that will not allow water to pond under the tent floor.
Clear a level area of all stones, twigs, etc.
Lay out tent with doors facing the desired direction.
Open doors and windows to allow air inside when standing tent up.

WARNING
Failing to open doors and windows will put excessive stress on the fabric as the tent is raised and may 
cause damage.  This damage is not covered by warranty.

Peg down the  corners of the tent. See Figure 1. Peg down all remaining peg loops.
Join tent poles sections together ensuring each section is firmly secured into the next. See Figure 2.

Step 2 - Install the ridge poles

Select the three ridge poles (1), slide one ridge pole through the sleeve that runs along the centre of the roof. 
Slide the remaining ridge poles through the loops along both sides of the roof. Make sure that you do not miss 
any loops including the webbing loops . See figure 1.

WARNING 
Do not force poles through the sleeves as this may damage the sleeve.  Check to ensure the pole does 
not snag when sliding it through the sleeve.

Select the six elbow poles (7) and connect them to the ends of the three ridge poles (1).  The three elbow 
poles (7) to be attached to the front of the tent need to be pushed up through the fabric socks in the awning 
roof.  The end of the elbow pole with the hole in the side should point to the ground.  With the webbing ties 
attached to the tent tie a knot onto the D rings of the elbow pole.  Please note to leave an equal distance at 
the front and the back of the tent between the tent and poles.

Step 3 - Install the upright poles 

Select the four corner upright poles (2) and connect them to the four corner elbow poles and have the two 
adjustable centre upright poles (3) ready to connect to the centre ridge elbow poles once the tent has been 
raised . See figure 2.

Step 4 - Standing the tent up

With a friend at one end of the tent and you at the other end of the tent, lift  one side of the tent until the side 
wall is fully upright and the corner upright poles (2) support the side of the tent.  Repeat this for the other side 
of the tent, the tent should now be supported by the four corner uprights (2).   Connect the two adjustable 
centre upright poles (3) and adjust height until tent sits correctly.

WARNING
Do not push the poles up too high as this may cause damage to the fabric.  This damage is not covered 
by warranty.
 

 

Содержание CT-1008













Отзывы: