Ozone ZENO 2, Руководство пилота

Страница: 10 / 34

08
Wing
To prepare the wing, lay it out on the top surface and perform a thorough daily check. You
should inspect the top and bottom surfaces for any rips and tears or any other obvious signs
of damage. Lay out the lines one side at a time, hold up the risers and starting with the brake
lines, pull all lines clear. Repeat with the B and A lines, including the upper C’s laying the
checked lines on top of the previous set. Make sure no lines are tangled, knotted or snagged.
Mirror the process on the other side and then inspect the lines for any visual damage.
Inspect the risers for any signs of obvious damage or wear. Ensure they are not twisted, pay
particular attention to the Dyneema AR3 risers as these are easily twisted.
Take-off checklist:
1. Check reserve parachute - pin is in and handle secure
2. Helmet on and fastened
3. All harness buckles closed - check leg-loops again
4. Risers connected to the harness correctly with carabiners and maillons tight
5. Accelerator system connected
6. Holding the A risers and your brake handles correctly
7. Leading edge open
8. Aligned in the middle of the wing and directly into wind
9. Airspace and visibility clear