PRE FLIGHT SET UP
10
11
ENGLISH
Speed System
An integrated speed-bar is included and already assembled. The glider-attachment ends are left intentionally long
in order to allow you to route it through the glider’s speed system if desired. If you choose to use the traditional
Brummel-hook system, simply trim the speed system to the desired length.
The speed system lines are routed through the holes found between the seat structure and the side skirt - just in
front of the pulleys on the side of the harness. After the pulleys the speed system lines go up through the small holes
located on the side panel. If you ever remount the speed system make sure that the lines pass to the outside of all
straps and underneath the lower foot plate lines on the inside of the pod.
Ensure the speed system lines are of equal length. Check that the lines are not too
short as this may inadvertently activate the speed system when under tension in the
air. Double check on the ground before flying.
Fitting the Ozium
Before your first flight, we recommend to suspend the harness from a suitably
strong point to check that it fits you correctly and to become familiar with the
features and adjustments. You can set the shoulder adjustment-straps to find
the best fit, and adjust the lumber support so that they leave you in a comfort-
ably reclined position.
To put the harness on first place the shoulder straps over your shoulders and bring the
leg/chest strap through your legs.
Fasten the leg/chest strap by placing the male buckles
through
the female buckles on each side
The automatic pod closing system should now be connected. First attach the right hand side, the
metal button can be found by the pulley under the right hand hang point. Put this button through the
loop on the left hand side of the pod.
Now pass the button on the left through the loop on the right hand
pod.
IMPORTANT: Make sure the structural
lines of the pod are running free and are
not caught around the leg/chest straps
when you fasten them.
