Ozone Hyperlink V3, Руководство пользователя

Страница: 14 / 24

14
1 2 3
Lay out the Kite and Speed Systems as you would for set up. Unwind the LSL line. Ensure there are no tangles or
knots in the line.
Disconnect the ISL line from the internal knot and pull the line out of the pocket. Ensure there are no tangles or knots in the line.
Open the undersurface zips (next to the centre of the kite)
to access the ISL lines (left and right) –
each line is stored inside the kite in a pocket on the rib (profile
section) with the line end attached to an internal knot.
Ensure the ISL is not twisted around the Diagonal Rib inside. Feed the ISL line through the plastic ring on the bridle line tab next to
the zip. Feed the line from the wing tip side towards the center.
Close the zip until 5mm before the slider goes into the bungee
cover, leaving room for the ISL line to run freely. Connect the two ISL lines coming out of the kite to the LSL
line, using a loop-to-loop connection.
iMPortant: 5-line Open Cell mOde is
reCOmmended fOr snOw and land use
Only. The air inTake valves musT be Open
when using 5-line mOde – if The valves
are nOT seT Open This will COmprOmise
The funCTiOnaliTy Of The inTernal re-
ride release sysTem and COuld Cause TO
damage TO The kiTe.
4
5
7 8 9
6
Repeat process for the other side.
4-line closed cell
to 5-line oPen cell
The line should be running freely from the neighboring
rib to the zip opening.