Ozone Angel v1, Руководство пилота

Страница: 9 / 23

INSTALLATION TO THE HARNESS
EN
06
The Angel is available with 2 bridle options: Short bridle or Y bridle.
The short bridle option is for harnesses that already have reserve bridles in place. Attach the parachute bridle to
the harness bridles using a Maillon Rapide 7mm screw gate maillon or similar.
The long Y bridle option is for harnesses that do not have bridles already installed. The attachment points should
be attached directly to the shoulder connection points using 2x 6mm screw gate stainless steel maillons (one for
each side) along with rubber bands or tape to secure the bridles neatly. You must NOT attach a long Y bridle to
any existing harness bridles. If your harness already has bridles attached to the shoulder hang points, you MUST
use the short bridle option. Only attach the Y bridle to the loops located on top of the shoulder straps which have
been specifically designed for mounting the rescue system.
Maillons must be closed tightly - finger tight then 1/2 a turn with pliers is sufficient. Do not overtighten.
Attach the reserve handle to one of the loops on the deployment bag using a small maillon or a larks foot knot.
Please refer to your harness manual to ensure the correct orientation.
The Angel is now ready to be installed into the deployment system of your harness. For detailed instructions of
fitting the Angel into the deployment system please consult your harness manual.
IMPORTANT:
You MUST NOT
attach the long Y
bridle to existing
harness bridle(s),
if this is the case,
you must use
the short bridle
option.
WARNING: Ozone strongly recommends that the reserve
parachute system is installed by a qualified professional.
Always seek experienced advice if you have any doubts.