Ozone Angel SQ, Руководство пилота

Страница: 5 / 12

INSTALLATION TO THE HARNESS
EN
06
05
The Angel SQ is available with 2 bridle options: Short bridle or Y bridle.
The short bridle option is for harnesses that already have reserve bridles in place. Attach the parachute bridle
to the harness bridles using a Maillon Rapide 7mm screw gate maillon or similar.
The long Y bridle option is for harnesses that do not have bridles already installed. The attachment points
should be attached to the shoulder connection points using 2x 6mm screw gate stainless steel maillons (one for
each side) along with rubber bands or tape to secure the bridles neatly.
You must NOT attach a long Y bridle to any existing harness bridles. If your harness already has bridles attached
to the shoulder hang points, you MUST use the short bridle option. Only attach the Y bridle to the loops located
on top of the shoulder straps which have been specifically designed for mounting the rescue system.
Maillons must be closed tightly - finger tight then 1/2 a turn with pliers is sufficient. Do not overtighten.
Attach the reserve handle to one of the loops on the deployment bag using a small maillon or a larks foot knot.
Please refer to your harness manual to ensure the correct orientation.
The Angel SQ is now ready to be installed into the deployment system of your harness. For detailed instructions
of fitting the Angel into the deployment system please consult your harness manual.
IMPORTANT:
You MUST NOT
attach the long Y
bridle to existing
harness bridle(s),
if this is the case,
you must use
the short bridle
option.
Bridle
Lines
Apex lines
Panels
Corner vents
WARNING: Ozone strongly recommends that the
reserve parachute system is installed by a qualified
professional. Always seek experienced advice if you
have any doubts.