2. ASSEMBLING THE STAND
3. ADJUSTING THE MITRE SAW
WARNING!
ENSURE THE MITRE LOCK HANDLE IS
TIGHT BEFORE MAKING A CUT. FAILURE TO DO SO MAY
RESULT IN THE ROTATING TABLE MOVING DURING
OPERATION AND CAUSE SERIOUS INJURY.
Assembling the Stand
Mitre Angle Adjustment
Limiting the Cutting Depth
Fixing the Mitre Saw to the Stand
2 Place the side panel onto the
handle panels and secure
each corner with 2, Ø6x12mm
screws, washers and nuts.
3 Secure the desired table
angle by turning the mitre lock
handle clockwise.
1 Loosen the mitre lock handle
and press the mitre adjustment
lever down.
1 Rotate the depth
stop outward so the
screw will contact
the stop.
2 Position the mitre saw onto the
stand making sure the holes
align.
Secure together with the 4
supplied Ø6x45mm bolts,
washers and lock nuts.
Note:
The mitre saw can be mounted to a bench following the same
process using 4 holes in the bench.
4 Place the upper supports onto
the side panel and position a
corner bracket over the top so
that the webbing touches the
side panel as shown.
Secure in place with 2
Ø6x20mm bolts, washers and
nuts into the side panels.
5 Repeat steps 3 and 4 with the other side panel to complete the stand
assembly.
b
a
1 Insert the legs into
the handle panels
and tighten with the
supplied Ø8x75mm
bolts, washers and
lock nuts.
Note:
Ensure they are
fitted so the rubber
feet will lay flat on the
ground.
For a more detailed assembly guide, please see the assembly manual.
2 Rotate the mitre
table to the desired
angle using the mitre
table angle scale.
2 Adjust the depth stop screw to
the required cutting depth by
rotating in or out.
1 Remove the 4 rubber
feet from the mitre
saw.
3 Insert the lower
supports into their
groves on one
handle panel and
secure each corner
with 2, Ø6x20mm
bolts, washers and
nuts.
Note:
The mitre table features click stops at 0
0
, 15
0
, 22.5
0
, 30
0
and 45
0
for quick setting.