ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
1. Retractable Safety Guard
2. Material Support Bar
3. Material Clamp
4. Fence
5. Mitre Table
6. Mitre Table Lock
7. Bevel Angle Pointer
8. Lock Down Pin
9. Spindle Lock Button
10. Trigger
MITRE SAW
KNOW YOUR PRODUCT
1. ASSEMBLY
1. Remove foam packaging materials and using the carry handle,
carefully lift the mitre saw from its box and place it on a level
work surface.
1. Squeeze the clamp at the
end of the dust bag, place
over the dust extraction
port.
1. Insert each bar into the
two holes located on
both sides of the base.
2. Release cutting head from its transport position. While holding
the head of the saw down release the lock down pin.
11. Carry Handle
12. Slide Lock
13. Bevel Lock
14. Dual Rail Slide Bar
15. Dust Bag
16. Laser Guide
17. Mitre Angle Pointer
18. Table Insert
19. Mitre Release
20. Release Lever
SETUP & PREPARATION
Unpacking
Material Support Bars
Dust Bag
WARNING!:
ENSURE THE TOOL IS SWITCHED
OFF AND DISCONNECTED FROM THE POWER
SUPPLY BEFORE PERFORMING ANY OF THE
FOLLOWING PROCEDURES.
HOLD
DOWN
TIGHTEN
2. Tighten screw when in
place.
Material clamp will assist
securing timber when making
cuts.
Note:
The clamp can be
mounted on either the left or
right.
Material Clamp
