8. Place a square against the rear fence (19) and
alongside the flat part of the blade (13) (Fig. 49).
9. Adjust the rear fence (19) until it is square with the
blade (13).
10. Tighten the four screws using the 6mm allen key (15)
and turning in a clockwise direction.
11. Loosen the Philips Head screw that holds the mitre
angle indicator (28) by turning in an anti-clockwise
direction (Fig. 50).
12. Adjust the mitre angle indicator (28) so that it
accurately indicates the zero position on the mitre
index scale (29).
13. Re-tighten the screw on the mitre angle indicator (28)
by turning in a clockwise direction.
14. Using a scrap piece of wood, perform a straight cut
at 0°.
15. Use a set square (not included), to check that the cut is accurate.
16. If the cut is not square, repeat steps 1-13 to set the rear fence (19) square with
the blade (13).
MAINTENANCE (cont.)
25
Fig. 50
Fig. 49
90º
