MAINTENANCE
DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
TROUBLESHOOTING
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
• Keep the ventilation vents of the saw clean at all times, if possible, prevent
foreign matter from entering the vents.
• After each use, blow air through the saw housing to ensure it is free from all dust
particles which may build up. Build up of dust particles may cause the saw to
overheat and fail.
• If the enclosure of the saw requires cleaning, do not use solvents but a moist
soft cloth only. Never let any liquid get inside the saw; never immerse any part of
the saw into a liquid.
Carbon Brushes
When the carbon brushes wear out, the reciprocating
saw will spark and/or stop. Discontinue use as soon
as this happens. They should be replaced prior to
recommencing use of the reciprocating saw. Carbon
brushes are a wearing component of the reciprocating
saw therefore not covered under warranty. Continuing
to use the reciprocating saw when carbon brushes
need to be replaced may cause permanent damage to
the reciprocating saw. Carbon brushes will wear out after many uses but when the
carbon brushes need to be replaced, take the reciprocating saw to an electrician
or a power tool repairer for a quick and low cost replacement. Always replace both
carbon brushes at the same time.
Note: Ozito Industries will not be responsible for any damage or injuries
caused by the repair of the reciprocating saw by an unauthorised person or by
mishandling of the reciprocating saw.
Sparking visible through the housing air vents
A small amount of sparking may be visible through the housing vents.
This is normal and does not indicate a problem.
Excessive sparking visible through the housing
air vents and/or the saw failing to operate
May indicate the carbon brushes have worn out and need to be
replaced. Carbon brushes should only be replaced by a qualified electrician or
power tool repairer.
Carbon Brushes (set)
SPRSW5100-10
Carbon Brush Holder (set)
SPRSW5100-12
Speed
Controller
SPRSW5100-02
Switch
SPRSW5100-03
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
V
Volts
Hz
Hertz
~
Alternating current
W
Watts
spm
Strokes per minute
Double insulated
Regulator compliance mark
Maximum cutting cap
for timber
Warning
n
o
No load speed
