2. PREPARATION
1. Lift up the grass catcher flap
with one hand and guide the
catcher with your other hand
over the two hooks on the
mower housing.
3. To remove, raise the grass catcher flap and lift the grass catcher out.
2. Lower the grass catcher and
allow it to sit in place. Lower
the grass catcher flap.
Adjusting the Cutting Height
Fitting and Removing the Grass Catcher
WARNING!
ONLY FIT AND REMOVE THE CATCHER
WHEN THE MOWER IS SWITCHED OFF AND THE
MOTOR HAS COME TO A STOP.
Note:
The grass catcher flap is
held against the grass catcher by
a spring.
WARNING!
ENSURE THE TOOL IS SWITCHED OFF
AND BATTERIES ARE DISCONNECTED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
Grass Catcher Handle Assembly
1. The handle will click into
position when aligned and
fitted correctly.
WARNING!
WHEN FITTING THE GRASS CATCHER
AFTER EMPTYING, ALWAYS ENSURE THERE IS NO
BUILD UP OF GRASS IN THE GRASS CHUTE.
Grass Catcher Indicator
The grass catcher is fitted with an
indicator at the rear of the catcher to
help identify when to empty.
If the indicator drops down while
operating then the grass catcher is full
and needs emptying.
1. Push lever downwards into the
mower body.
The height adjustment lever provides 5 cutting heights from 25mm to 65mm.
2. Adjust until the required cutting
height is selected.
35
45
55
65
WARNING!:
BE CAREFUL DURING CUTTING HEIGHT
ADJUSTMENTS TO PREVENT ENTRAPMENT OF THE
FINGERS BETWEEN MOVING HEIGHT ADJUSTMENT
LEVER AND THE MOWER HOUSING.
3. Release lever and check that it is
securely seated in the required
cutting height.
