2. INSERTING AND REMOVING BATTERY
1. Open the battery cover.
1. Open the battery cover.
3. Insert the safety key.
(If the mower is not going to be
used immediately, do not insert
the safety key.)
2. Press the battery release tab and
remove the battery.
1. Lift up the catcher flap with one
hand and guide the catcher with
your other hand over the two
hooks on the mower housing.
3. To remove, raise the flap and lift
the catcher out.
2. Slide the battery into the mower
aligning the ribs so that it clicks
into place.
4. Close the battery cover.
3. Close the battery cover.
2. Lower the grass catcher and allow
it to sit in place. Lower the catcher
flap.
Inserting Battery into the Mower
Removing the Battery from the Mower
Fitting and Removing the Grass Catcher
IMPORTANT!
ONLY FIT AND REMOVE THE CATCHER
WHEN THE MOWER IS SWITCHED OFF AND THE
MOTOR HAS COME TO A STOP.
1. Locate cord on outside of handle. Secure the power cord from the switch
housing to the mower using 2 cable ties (supplied).
Note:
Care should be
taken not to impinge
cord when folding down
the handle.
Securing the Cord
Ensure the cord follows the handle smoothly from the switch to the body of
the mower.
Note:
The catcher flap is held
against the grass catcher by a spring.
Grass Catcher Assembly
1. To assemble the grass catcher
align the two halves and push
them together, one side at a
time. Ensure the two halves
click together around the entire
middle section.
2. Assemble the grass catcher
handle onto the opening on the
top half of the grass catcher.
The handle will click into
position when aligned and fitted
correctly.
For best performance use 3.0Ah battery and above.
