6. TROUBLE SHOOTING
MAINTENANCE
7. CLEANING & MAINTENANCE
IMPORTANT!
BEFORE CLEANING YOUR HIGH PRESSURE
CLEANER OR CARRYING OUT ANY MAINTENANCE
PROCEDURE, MAKE SURE THAT THE MOTOR IS OFF AND
THE TOOL DISCONNECTED FROM THE POWER SUPPLY
TO PREVENT ACCIDENTAL STARTING.
IMPORTANT!
WAIT UNTIL THE HIGH PRESSURE CLEANER
HAS COMPLETELY COOLED DOWN. RISK OF BURNS!
Cleaning
• Keep the safety devices free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with compressed
air at low pressure.
• We recommend that you clean the appliance immediately after you
use it.
• Clean the appliance regularly with a damp cloth and some soft
soap. Do not use cleaning agents or solvents; these may be
aggressive to the plastic parts in the appliance. Ensure that no
water can get into the interior of the appliance.
• You must disconnect the hose and any spraying tools from the
compressor before cleaning. Do not clean the compressor with
water, solvents or the like.
Testing the water intake filter
Periodically check the intake filter in
order to prevent clogging, which could
jeopardize operation of the pump.
To do this, unscrew the connector
for the water inlet hose from the
high pressure cleaner and clean the
exposed inlet sieve under running
water.
Problem
Cause
Solution
The high pressure
cleaner does not start
1. No power supply
1. Check the power
supply, the power
plug and the
socket-outlet.
2. Insufficient supply
power
2. Make sure that
the extension
cable is not too
long.
3. Outside temperature
is too low
3. Never operate
with an outside
temperature of
below 5°c.
4. Motor is overheated
4. Allow the motor
to cool down.
If necessary,
remedy the
cause of the
overheating.
The motor starts but
there is no pressure
build-up
1. Water intake filter is
clogged
1. Clean the water
intake filter
2. Air intake in the
water inlet
2. Check the supply
hose and hose
connectors
and replace if
necessary
3. Water tap closed
3. Turn open the
water tap
The operating
pressure is irregular
1. Air intake in the
water inlet
1. Check the supply
hose and hose
connectors
and replace if
necessary
