13
OPERATION (cont.)
2. Feed the two bars on the parallel guide fence (7)
through the holes in the router base, located on the
right hand side of the router in the feed direction.
This will assist in keeping the guide flush with the
side of the work piece (Fig 16).
3. Adjust the distance between the router bit and
parallel guide fence (7) by moving the guide until it
is at the correct distance from the router bit and the
cut you are making.
4. Tighten the parallel guide locking knobs (13) by rotating clockwise, to hold the
parallel guide fence (7) in position.
Note:
If the distance between the side of the work piece and the cutting position is
too wide, or the side of the work piece is not straight, firmly clamp a straight board to
the work piece and use this as a guide against the flat of the router base.
Using the Dust Extraction Adaptor
The dust extraction adaptor (9) will accept most standard
vacuum cleaner nozzles allowing the dust to be
efficiently removed when the tool is in use.
Fit the dust extraction adaptor (9) into the base as shown
in Fig.17.
Ensure that the suction hose that will be used is a
reinforced hose such as a garden hose or a wire
reinforced hose. If you use a non-reinforced hose, the hose can collapse and reduce
the suction therefore limiting the extraction of debris and dust.
Using the Copy Template Guide
The copy template guide (10) can be used in various ways:
•
Producing duplicates of a particular design of an original shape.
•
In conjunction with a template, producing decorative features.
•
Repetitive shape cutting.
1. To attach the template guide (10) turn the router upside down and remove the
two fixing screws by rotating them anti-clockwise. These screws also hold the dust
extraction shroud in place. The dust extraction shroud is the clear shroud located
on the underside of the router base (Fig.8).
2. Insert the template guide (10) into the base of the
router with the raised collar facing up or out from
the base plate of the router (Fig.18).
3. You will need to hold the dust extraction shroud in
it's position with your other hand prior to screwing
the template guide (10) into position.
Fig. 17
Fig. 16
Fig. 18
Содержание PRR-1200
Страница 1: ......
