Connecting to
the discharge outlet
1. Teflon tape (not included) is required on
threads to ensure a water tight seal and
prevent any leakage. Wind Teflon clockwise
on fittings
2. Remove the plastic protection cover
from the discharge outlet.
3. Insert a 1” male threaded hose
adaptor (not included).
4. Securely attach the output hose
or pipe (not included) to the
other end of the adaptor. Ensure
you have the correct diameter
hose or pipe that is compatible
with your water discharge
application.
Note:
The discharge hose or pipe you are using must have a minimum
diameter of
19mm (3/4’’).
Note:
Ensure the discharge hose or pipe is not restricted in any
way and nothing is obstructing the hose or pipe when the pump is in
operation.
Connecting to the suction inlet
1. Teflon tape (not included) is required
on threads to ensure a water tight seal
and prevent any leakage. Wind Teflon
clockwise on fittings.
2. Remove the plastic protection cover
from the suction inlet.
3. Insert a 1”
male threaded
hose adaptor
(not included).
Tighten firmly
with a spanner
(not included).
4. Securely attach
the input hose
(not included)
or pipe to the
other end of the
adaptor. Ensure
you have the
correct diameter
hose or pipe that
is compatible
with your water
drawing source.
Note:
The suction pipe should have an internal diameter of at least
25.4mm (1”); it must be kink resistant and suitable for pump use.
Ensure the input hose or pipe is not restricted in any way.
2. SUCTION INLET
3. DISCHARGE OUTLET
0
1
2
3
4
5
6
Bar
0
1
2
3
4
5
6
Bar
0
1
2
3
4
5
6
Bar
0
1
2
3
4
5
6
Bar
0
1
2
3
4
5
6
Bar
0
1
2
3
4
5
6
Bar
0
1
2
3
4
5
6
Bar
0
1
2
3
4
5
6
Bar
0
1
2
3
4
5
6
Bar
0
1
2
3
4
5
6
Bar
WARNING!:
RISK OF INJURY! IF THE COMPONENTS
ARE NOT COMPRESSION-PROOF OR IF THEY ARE
IMPROPERLY INSTALLED, THE PRESSURE LINE COULD
BURST DURING OPERATION.
