OPERATION (cont.)
12
Chiseling
Rotate the mode selector on the side of the drill to the hammer icon, and rotate
the rear mode selector to the drill and hammer icon. This setting is recommended
for use when desiring a hammer action without the accessory rotating which is
ideal for “chiseling or chipping” away at masonry products or files, point or chisel
accessory bits should be used.
Drilling
Rotate the mode selector on the side of the drill to the hammer and drill icon, and
rotate the rear mode selector to the drill icon. This setting is recommended for use
when you desire the accessory to rotate without hammer action. Ideal for drilling
into timber or steel when correct accessories for such materials are used.
•
Keep the ventilation vents of the tool clean at all times, if possible, prevent
foreign matter from entering the vents.
•
After each use, blow air through the tool housing to ensure it is free from all
dust particles which may build up. Build up of dust particles may cause the
tool to overheat and fail.
•
If the enclosure of the tool requires cleaning do not use solvents but a moist
soft cloth only. Never let any liquid get inside the tool; never immerse any part
of the tool into a liquid.
Gear box grease replenishment
The grease in the gearbox will require replenishment after approximately 50 hours
accumulative use. After this time add approximately 50 grams (approx 2 – 3 tea
spoons) of the grease (supplied), into the gearbox. First remove the grease cap (5)
from the tool by using the pin spanner (21). Once removed, add the grease
through this hole. Ensure the grease cap (5) is secured back into position prior to
operation. Further grease (
normal ball bearing grease
) can be purchased through
you local Bunnings Warehouse.
Side mode selector
Rear mode selector
Side mode selector
Rear mode selector
MAINTENANCE
