Never splash or clean the welder with water.
Store the welder in a dry place.
If necessary, clean the welder using a damp/moist rag, disconnect from the power
supply prior to cleaning.
Keep the ventilation slots of the welder clear at all times and prevent foreign matter
from entering the housing.
Torch
The contact tip and shroud must be cleaned regularly to remove spatter which will
eventually disturb the wire flow anti-spatter spray sprayed onto the shroud and the tip
will reduce the build up of spatter. Replace the tip regularly as a good electrical contact
between the top and wire is essential. Avoid kinking the torch and never use it to pull
the machine around to ensure the wire passes freely through the torch tip and liner.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by the
repair of the welder by an unauthorised person or by mishandling of the welder.
11
MAINTENANCE
CONTENTS
OZITO INDUSTRIES PTY LTD
AUSTRALIA (Head Office)
5 Chestnut Crt, Dingley, Victoria, Australia, 3172
Telephone: 03 9558 3999
Facsimile: 03 9558 0583
www.ozito.com.au
1 x Mig Welder OZMW90A
1 x Combination wire brush
and chipping hammer
1 x Welding Mask
1 x Instruction Manual