2. OIL
IMPORTANT:
IT IS VITAL FOR THE PROPER AND SAFE
OPERATION OF THE CHAINSAW THAT THE CHAIN IS
TENSIONED CORRECTLY.
IMPORTANT:
THE CHAIN SHOULD BE ADJUSTED
BEFORE FIRST USE, AGAIN AFTER 2-3 MINUTES OF
OPERATION AND RECHECKED AND ADJUSTED IF
NECESSARY AFTER EACH 30 MINUTES OF USE. TAKE
CARE NOT TO OVER TENSION THE CHAIN.
IMPORTANT:
ONLY USE OIL THAT IS EXPRESSLY
LABELLED “CHAIN BAR OIL”.
WARNING!:
NEVER START WORK UNLESS THE
CHAIN AND BAR ARE LUBRICATED.
5. To check the lubricating system,
switch on the chainsaw and hold it
with the guide bar and chain above
some light coloured paper such as
newspaper. A steadily increasing
stain caused by oil spray shows the
lubricating system is working.
18V L
ITHIU
M
ION
18V
LIT
HIU
M
PO
W
ER
ED
BY
POW
ERE
D B
Y
IO
N
18V LIT
HIUM
ION
18V LITHIUM
POWERED BY
POW
ERED
BY
ION
2. Fill the tank with chain bar oil.
The capacity of the chain oil
tank is 220ml. Do not over fill.
Adjusting the chain tension
3mm gap is
the ideal tension
1. Loosen the guide bar locking knob
slightly, by rotating it in an anti
clockwise direction.
2. Adjustment chain tension
screw CLOCKWISE to increase
chain tension. Turning screw
COUNTERCLOCKWISE will
decrease amount of tension on
the chain. Adjust the chain tension
screw for the correct tension.
3mm gap is
the ideal tension
For the correct chain tension, pull up
on the chain from the top and middle
of the exposed guide bar. The bottom
tip of the links should only just stay in
the track.
3mm gap is
the ideal tension
3. After the chain has been accurately
tensioned, lock the guide bar in place with
the side cover lock.
3mm gap is
the ideal tension
1. Remove the chain oil tank cap
3. Always fill the oil tank when
the oil level is below the
minimum mark on the oil level
window
.
4. Refit cap and clean any
oil spillage.
NOTE:
Chain bar oil may leak if the tool is left for long periods. This is
normal. If the tool is to be left unused for an extended time, drain the oil
from the tool. Refill before use.
18V L
ITHIU
M
ION
18V
LIT
HIU
M
PO
W
ER
ED
BY
POW
ERE
D B
Y
IO
N
18V LIT
HIUM
ION
18V LITHIUM
POWERED BY
POW
ERED
BY
ION
18V L
ITHIU
M
ION
18V
LIT
HIU
M
PO
W
ER
ED
BY
POW
ERE
D B
Y
IO
N
18V LIT
HIUM
ION
18V LITHIUM
POWERED BY
POW
ERED
BY
ION
18V L
ITHIU
M
ION
18V
LIT
HIU
M
PO
W
ER
ED
BY
POW
ERE
D B
Y
IO
N
18V LIT
HIUM
ION
18V LITHIUM
POWERED BY
POW
ERED
BY
ION