BATTERY LOAD TESTER
W
ARNING: VER
Y HOT SURF
ACE!
READ FULL INSTRUCTIONS BEFORE USE!
BATTERY LOAD TESTER
W
ARNING: VER
Y HOT SURF
ACE!
READ FULL INSTRUCTIONS BEFORE USE!
LOAD TEST SWITCH
OFF / ON
(0) / (—)
LOAD TEST SWITCH
OFF / ON
(0) / (—)
VOLTS
VOLTS
B
A
D
W
E
A
K
B
A
D
W
E
A
K
O
K
6-VOLTS
12-VOLTS
OK
CHARGING
SYSTEM
1000
800
600
400
200
+
-
+
-
+
-
a.
b.
1. Turn off vehicle ignition, all electronics and any loads.
2. With the vehicle engine turned off,
connect the red positive terminal
clamp to the positive ( + ) pole on
your vehicles 12V or 6V lead acid
battery.
3. Connect the black negative terminal
clamp to the negative (
–
) pole on
your vehicles battery.
Disconnecting from a Vehicle Battery
1. Remove the black negative terminal
clamp from the negative ( – ) pole of
your vehicle battery.
2. Remove the red positive terminal
clamp from the positive ( + ) pole of
the vehicle battery.
KNOW YOUR PRODUCT
1. BATTERY CONNECTION
SETUP & PREPARATION
ONLINE MANUAL
Scan this QR Code with your mobile
device to take you to the online manual.
1. Load Test Switch
2. Meter
3. Black Negative Terminal Clamp (
–
)
4. Cooling vents
5. Carry Handle
6. Red Positive Terminal Clamp (+)
BATTERY LOAD TESTER
5
6
1
2
3
WARNING!
ENSURE THE POWER CORD IS UNCOILED
AND FULLY EXTENDED TO AVOID OVERHEATING
THE POWER CORD. ENSURE THAT IT DOES NOT GET
TANGLED OR CAUGHT IN ANY ROTATING PARTS
WITHIN THE ENGINE COMPARTMENT OF THE VEHICLE.
Connecting to a Vehicle Lead Acid Battery
Note:
During first use, you will notice a little smoke and/or a burning smell
coming from the unit. This is normal and will stop after a short burn-in
period.
Before testing make sure the battery terminals are really clean as grease
and dust could lead to errors in the test results. The battery MUST be
disconnected prior to cleaning. Check the battery and connections for any
cracks or damage before proceeding with cleaning and testing. To help
ensure a good connection of the battery load tester clamps, clean the
battery terminals with a solution of baking soda and water, and wipe the
battery terminals with a cloth to remove any dirt, grease and any residual
water.
WARNING!
READ AND UNDERSTAND THE WARNINGS
BEFORE SETUP AND TESTING.
WARNING!
CHECK CORD AND CLAMP FOR DAMAGE
BEFORE EVERY USE. DO NOT USE IF CORD OR CLAMP
INSULATION IS MISSING OR DAMAGED AND WIRE IS
EXPOSED.
7
8
9 10
11
7. 6V Load Test Range
8. 12V Load Test Range
9. Cold Cranking Amps Range
10. Charging Test Range
11. Starter Test Voltage Scale
WARNING!
THE METAL HOUSING WILL GET VERY HOT
AND WILL BURN SKIN OR CAUSE PROPERTY DAMAGE;
WEAR PROTECTIVE GLOVES AND DO NOT PLACE
HANDS, BODY OR ANY OBJECTS NEAR THE COOLING
VENTS AREA.
4