Turning The Unit On & Off
1. To switch the unit on, rotate
the 3 speed on/off dial
clockwise to the ‘I’, ‘II’ or ‘III’
position.
WARNING!
DO NOT MOVE OR CARRY THE AIR
MOVER WHILE IT IS IN OPERATION.
WARNING!
DO NOT LEAVE THE AIR MOVER
UNATTENDED WHILST IT IS IN OPERATION.
2. To switch the unit off, turn the
dial anti-clockwise to the ‘0’
position.
Changing The Air Speed
1. For quick drying applications,
rotate the on/off dial to the ‘III’
position.
2. Rotate the dial to the ‘I’ position for slower air output.
Overload Protection
The tool is equipped with an overload protection feature. If an
overload occurs, the tool will automatically shut off to protect the tool.
1. In the event of an overload
turn the on/off dial to the ‘0’
position, allow the tool to
cool down and remove any
obstructions from the inlet or
outlet.
2. Ensure nothing will obstruct the air inlet grills on either side during
operation.
3. Press the reset button and
restart the air mover as
normal.
WARNING!
DO NOT CONTINUE USING THE
UNIT IF THE OVERLOAD SWITCH TRIPS AGAIN
IMMEDIATELY AFTER THE RESET; CONTACT OZITO
CUSTOMER SERVICE.
2. CONTROLS
OPERATION
III
II
I
0
AIR MOVER
III
II
I
0
AIR MOVER
III
II
I
0
AIR MOVER
III
II
I
0
AIR MOVER
III
II
I
0
AIR MOVER
WARNING!
THE POWER SUPPLY FOR THIS
PRODUCT SHOULD BE PROTECTED BY A
RESIDUAL CURRENT DEVICE (RATED AT 30mA OR
LESS).
WARNING!
DO NOT OPERATE THE AIR MOVER IN
AN EXPLOSIVE ENVIRONMENT. DO NOT USE OR
STORE THE AIR MOVER WITH OR NEAR FUELS,
GRAIN, DUST, SOLVENTS, THINNERS OR OTHER
FLAMMABLE MATERIALS.
WARNING!
BEFORE AND AFTER EACH USE,
THOROUGHLY INSPECT THE UNIT AND POWER
SUPPLY CORD FOR SIGNS OF WEAR OR DAMAGE.
IF REPLACEMENT OF THE SUPPLY CORD IS
NECESSARY, THIS HAS TO BE DONE BY A
CERTIFIED ELECTRICIAN IN ORDER TO AVOID A
SAFETY HAZARD.