Setting The Speed
Rotate the speed control dial to
the desired speed setting.
Use a high speed setting to remove material quickly or a lower setting
for more control.
WARNING!
DO NOT ADJUST THE SPEED OF THE
SANDING DISC WHILE SANDING WORKPIECES IS IN
PROGRESS.
Starting The Sander
1. Press the on/off switch to the ‘I’
position to turn the sander on.
2. Press the switch to the ‘0’ position
to turn the tool off.
WARNING!
ENSURE THAT THE BENCH DISC
SANDER IS CLAMPED SECURELY BEFORE
SANDING.
Sanding Procedure
The arrow on the top of the sanding
wheel indicates the direction of rotation.
WARNING!
DO NOT ATTEMPT TO SAND MATERIAL
ON THE RIGHT HALF OF THE SANDING DISC.
THIS WILL CAUSE THE WORKPIECE TO FLY OFF
THE TOOL AND POTENTIALLY CAUSE PERSONAL
INJURY OR DAMAGE TO BYSTANDERS.
1. Fit the appropriate grit sandpaper to the sanding wheel.
2. Set the sanding speed with
the control dial, plug in the
power cord and switch on the
sander.
3. Allow the sander to reach full
speed and run without load for
a minute.
4. While maintaining a firm grip
on the workpiece, hold the
surface to be sanded against
the sanding sheet.
Note:
Move it steadily back and
forth across the sanding disc
to ensure even wear and to
prolong the life of the sandpaper.
WARNING!
NEVER USE THE BENCH SANDER
WITHOUT THE TILT TABLE & DISC FENCE IN PLACE.
MBDS-125
4. CONTROLS
5. USAGE
OPERATION
WARNING!
THIS PRODUCT IS NOT RECOMMENDED
FOR SANDING DRYWALL OR PLASTER DUE TO THE
ULTRA-FINE SANDING PARTICLES PRODUCED.
DRYWALL SANDERS IN CONJUNCTION WITH DUST
EXTRACTION ARE RECOMMENDED FOR DRYWALL
AND PLASTER SANDING APPLICATIONS.
WARNING!
THE TOOL MUST BE USED WITH A
RESIDUAL CURRENT DEVICE WITH A RATED
RESIDUAL CURRENT OF 30mA OR LESS.
WARNING!
DO NOT LEAVE THE TOOL UNATTENDED
WHILE THE ON/OFF SWITCH IS IN THE ON
POSITION.