Sandpaper Fitment
1. Unwind the left table adjustor
screw completely. Remove
the screw caps and washer
from one end, and pull the
axle out of the slot.
2. Slide the tilt table off the tool.
3. Slide the disc fence out and
pull the used sandpaper sheet
off the hook & loop backing.
Replace it with a new sheet.
4. Replace the disc fence, then
slide the tilt table back onto
the sander, making sure to
align the angle rails in the
channels on each side of the
tool.
5. Re-insert the table adjustor axle into the slot, ensuring there is a
washer on either end of the axle, and tighten the table adjustor
screws back into place.
WARNING!
DO NOT START THE TOOL UNTIL ALL
COMPONENTS ARE COMPLETELY ASSEMBLED.
Adjusting The Tilt Table
1. Loosen the table adjustor
screws slightly.
2. Rotate the angle increment dial
to adjust the table to the desired
angle.
3. Tighten the table adjustor
screws to lock the table in
place.
Adjusting The Mitre Guide
1. Loosen the fence adjustor screw.
2. Rotate and slide the mitre fence to
the desired angle and position.
3. Tighten the fence adjustor screw to
lock the mitre fence in place.
3. ADJUSTING THE SANDER
WARNING!
ENSURE THE TOOL IS TURNED OFF
AND DISCONNECTED FROM THE POWER SUPPLY
BEFORE PERFORMING ANY OF THE FOLLOWING
OPERATIONS.
WARNING!
ENSURE THE TOOL IS TURNED OFF
AND DISCONNECTED FROM THE POWER SUPPLY
BEFORE PERFORMING ANY OF THE FOLLOWING
OPERATIONS.