4. CONTROLS
OPERATION
1 To switch ON, depress the
On/Off switch.
1 Depress the head angle
lock button to allow the
head to tilt.
1 Press the rotating head
lock button up to allow the
head to tilt.
2 To switch OFF, release the
On/Off switch.
2 Rotate the cutter head into
the required position and
release the head angle
lock button.
2 Rotate the head into the
required position and
release the rotating head
lock button.
Ensure the cutter head angle is locked into place before
operating.
Ensure the head is locked into place before operating.
The line trimmer is fitted with a rotating head to allow for edging
and trimming. To switch between the 2 modes, the head must
be rotated following the steps below.
On/Off Switch
Adjusting the Cutter Head Angle
Trimming and Edging Modes
Trimming Mode
Edging Mode
CAUTION:
TO REDUCE THE RISK OF ELECTRICAL SHOCK,
A RESIDUAL CURRENT DEVICE (RATED 30MA OR LESS)
SHOULD BE USED.
WARNING!
THE LINE TRIMMER MAY RUN FOR A FEW
SECONDS AFTER IT HAS BEEN SWITCHED OFF. LET THE
MOTOR COME TO A COMPLETE STANDSTILL BEFORE
SITTING THE TOOL DOWN.
