11
assembling the Grass catcher
Assemble the two halves of the grass catcher (5)
together. Align the two halves and push each
individual plastic lug into its opposite location.
Start at the rear and work your way forward.
Ensure that all the plastic lugs engage correctly
with a “Click” together around the entire middle
section (Fig. 5).
Fasten the two halves of the grass catcher (5)
together with the screws located as shown in
Fig. 6 on either side.
fitting and removing the grass catcher
The grass catcher (5) must be attached to the two raised
hooks on either side of the mower (Fig. 7).
Lift up the grass catcher flap (4) with one hand and
guide the grass catcher (5) with your other hand
over the two raised hooks on either side of the
mower housing (Fig. 8).
Lower the grass catcher (5) and allow it to sit in
place. Lower the grass catcher flap (4).
To empty the grass catcher (5), lift the grass catcher flap (4) with one hand then
lift the grass catcher (5) with the other hand up off the two raised hooks on either
side of the mower.
1.
2.
1.
2.
3.
aSSemBly (cont.)
Fig. 7
Fig. 8
WarninG!
Before performing any maintenance on cleaning, make
sure the mower battery and safety key are removed from to avoid
accidental starting and possible serious injury.
After emptying the grass catcher (5) ensure the mowers discharge chute is
clear from grass build up before re-assembling the grass catcher (5) onto
the mower.
Fig. 5
Fig. 6