DESCRIPTION OF SYMBOLS
TROUBLESHOOTING
SPARE PARTS
Read instruction manual.
Nm
Newton Meters
Always keep the lawnmower on the ground when mowing.
Tilting or lifting the lawnmower may cause stones to be thrown out.
Beware of servering toes or hands. Do not put hands or feet near
a rotating blade.
Do not mow in the rain or leave the lawnmower outdoors while raining.
Keep bystanders away. Do not mow whilst people especially children
or pets are in the mowing area.
Blade continues to rotate after the machine is switched off. Wait
until all machine components have completely stopped before
touching them.
Ensure the engine is off and is cool, disconnect the spark
plug before doing any maintenance, repair, cleaning or
adjustment work.
Regulator compliance mark
96
Sound power level
Fill with oil and fuel
before starting the mower.
Fill with fuel only when the engine is off and cool.
WARNING! Hot parts. Keep your distance.
Wear ear and eye protection.
CARING FOR THE ENVIRONMENT
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito customer service
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
Ozito Industries will not be responsible for any damage or injuries caused by
repair of the tool by an unauthorised person or mishandling or mistreatment of
the tool. This tool is designed for domestic home use only. Use in commercial
or industrial environments will void the warranty.
• Keep all nuts, bolts and screws tight to be sure the lawn mower is in a safe
working condition.
• Check the catcher frequently for wear or deterioration.
• Replace worn or damaged parts for safety.
•
Only use the replacement blade and blade bolt specified for this product.
• Be careful during adjustments of the lawn mower to prevent entrapment of the
fingers between moving blade and fixed parts of the machine.
• When not in use, the mower should be stored in a dry, frost-free location, out
of reach of children. If the housing of the mower requires cleaning, do not use
solvents but a moist soft cloth and brush only.
• If the lawn mower is not going to be used for an extended period, empty the
petrol tank using a petrol suction pump.
Tools that are no longer usable should not be disposed of with
household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council
authority for recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution in the
environment. Please recycle packaging where facilities exist.
Check with your local council authority for recycling advice.
Inspecting the V-Belt
To inspect the V-belt you must remove
the V-belt cover.
Problem
Cause
Remedy
The equipment
does not operate
smoothly and
vibrates intensively
- Screws are loose
- Blade fasteners are loose
- Blade is unbalanced
- Check screws
- Check blade fasteners
- Replace blade
Engine does not
start
- Start/stop lever not pressed
- No fuel in carburettor
- Fuel tank is empty
- Press start/stop lever
- Prime the carburettor
- Refill with fuel
Uneven mowing
results
- Blade is blunt
- Cutting height is too low
- Sharpen the blade
- Set correct height
Unsatisfactory
bagging of the
grass
- Cutting height is too low
- Blade is worn
- Grass catcher is clogged
- Set correct height
- Replace the blade
- Empty the grass catcher
Engine does not run
smoothly
- Air filter dirty
- Spark plug dirty
- Clean air filter
- Clean or replace spark plug
Mower hard to push - Height of cut too low
- Cutting blade blunt
- Possible clogging
- Grass too long
- Grass to dense
- Wet grass
- Raise cutting height
- Replace blade
- Check underneath the mower
and clear out as necessary
- Raise the cutting height
- Raise the cutting height and
walk slower and cut more
frequently
- Wait until grass dries before
mowing
Grass chute is not
clean
- Engine speed too low
- Cutting height too small
- Blade is worn
- Grass catcher is clogged
- Increase engine speed
- Set properly
- Replace the blade
- Empty grass catcher
Starter does not
turn
- Battery empty
- Battery not connected
- Safety key not fitted
- Charge battery
- Connect battery
- Fit safety key
WARNING!:
BEFORE MAKING ADJUSTMENTS OR
REPAIR TO THE ENGINE REMEMBER THAT THE
EXHAUST AND OTHER PARTS WILL BE HOT. DO NOT
TOUCH THESE PARTS AS THEY MAY BURN YOU.
