2. PREPARATION
Mulching Adaptor
Securing the Cords
1. Pull lever outwards away
from the mower body.
2. Adjust until the required
cutting height is selected.
3. Release lever and check
that it is securely seated in
the required cutting height
position.
Ensure the cord follows
the inside of the handles
smoothly from the Power-X
Panel to the body of the
mower.
WARNING!:
ONLY FIT AND REMOVE THE CATCHER WHEN
THE ENGINE IS SWITCHED OFF AND THE MOTOR HAS
COME TO A STOP
Fitting and Removing the Grass Catcher
1. Lift up the grass catcher flap
with one hand and guide the
catcher with your other hand
over the two hooks on the
mower housing.
2. Lower the grass catcher and
allow it to sit in place. Lower
the grass catcher flap.
NOTE:
The grass catcher flap is
held against the grass catcher by
a spring.
3. To remove, raise the grass
catcher flap and lift the grass
catcher out.
WARNING!:
WHEN FITTING THE GRASS CATCHER AFTER
EMPTYING, ALWAYS ENSURE THERE IS NO BUILD UP OF
GRASS IN THE GRASS CHUTE.
Grass Catcher Indicator
The grass catcher is fitted with an
indicator at the rear of the catcher
to help identify when to empty.
When in operation the indicator
floats up when the catcher is
empty. If the indicator drops down
then the grass catcher is full and
needs emptying.
WARNING!:
ENSURE THE ENGINE IS SWITCHED OFF AND
THE MOTOR HAS COME TO A STOP BEFORE PERFORMING
ANY OF THE FOLLOWING TASKS.
Adjusting the Cutting Height
The cutting height adjustment lever provides 6 cutting heights
from 25mm - 70mm.
In mulching mode the cuttings are shredded in the enclosed
mower housing and then spread back onto the lawn.
1. To use the mulching
function, remove the
grass catcher, slide the
mulching plug through the
ejector opening and close
the grass catcher flap.
NOTE:
Mulching is only
possible if the lawn is
relatively short.
Side Ejector Adaptor
NOTE:
The mulching adaptor must be fitted in order to use the
side ejector.
1. Lift up the side ejector
flap with one hand and
guide the side ejector
adaptor with your other
hand onto the mower
housing.
2. Lower the side ejector
adaptor and allow it to sit
in place. Lower the side
ejector flap.
