![background image](http://html1.mh-extra.com/html/ozito/dtp-065/dtp-065_instruction-manual_1666898007.webp)
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority for
recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your local
council authority for recycling advice.
Make sure to shut off the engine, allow the engine to cool before
performing maintenance procedures.
Use a moist cloth to wipe down the pump housing. Allow to dry
thoroughly before storing in a dry location that is protected from bad
weather conditions.
Note:
Ozito will not be responsible for any damage or injuries caused
by repair of the pump by an unauthorised person or by mishandling.
TROUBLESHOOTING
MAINTENANCE
DISPOSAL AND RECYCLING
Problem
Possible Cause
Solution
Unit runs but delivers little or no
water
Leak in suction hose or piping
Clogged suction filter
Water level above pump intake
Pump not primed
Water level more than maximum lift
Engine speed too low
Tighten suction hoses and use thread sealer.
Clear debris from suction filter
Lower suction hose into water
Follow priming procedure in this manual
Move pump closer to water level and increase discharge line length if necessary
Increase throttle
Unit will not start
No fuel
Fuel tap in “off” position
Oil level too low
Low quality or deteriorated, old fuel
Air-filter clogged
Temperature too hot or cold for the oil being used
Fill engine fuel tank. Refer to engine operating instructions
Turn fuel valve to “on” position
Fill with correct oil
Use only fresh diesel fuel
Check, clean or replace filter as required
Refer to maintenance section for the correct oil and replace if required
Unit starts but runs and performs
poorly
Air-filter clogged
Engine or carburettor difficulties
Check, clean or replace filter as required
Contact Ozito customer service
MAINTENANCE CHART
*
Item
Time
*
*
Recommended Check & Maintenance Chart
Inspect and tighten nuts and bolts
Every operation / daily
Engine Oil
Oil Filter
Air Filter
Fuel Tank
Fuel Filter
Nozzle
Injection Pump
Fuel Lines
Adjust inlet and exhaust valves
Grind inlet and exhaust valve holders
Change Piston Rings
Check accumulator fluid
Check
Change
Clean
To be performed by qualified service centre
After 20 hours or
1 month
After 100 hours or
3 month
After 300 hours or
6 month
After 1000 hours or
yearly
(top up if required and
check for leaks)
(only required after first
20 hours / 1 month of use)
(Frequency depends on pump location. i.e. High dust environment every 10 Hrs)
(change if neccesary)
(required after first
20 hours / 1 month of use)