OPERATION (cont.)
11
Chain Oiling
The guide bar (7) and chain (6) require lubrication
to reduce friction, the automatic oiler provides
lubrication to the chain (6) and guide bar (7) while
the chainsaw is operating.
Always fill the oil tank prior to using the chainsaw
(Fig. 7), if oil is not used you will quickly damage
the guide bar (7) and chain (6)(such damage is not
covered under warranty). To fill the oil tank,
unscrew the chain oiling filler cap (10), make sure
no dirt gets into the oil tank. Fill the oil tank until
full and replace the cap. Never use the chainsaw
when the oil level is below the minimum mark on the oil level window (11). Always
fill the oil tank before the oil level gets to the minimum mark on the oil level
window (11).
Checking the Chain Lubrication
To check the lubricating system, switch on the chainsaw and hold it with the guide
bar (7) and chain (6) above some light coloured paper (newspaper). A steadily
increasing stain caused by oil spray shows the lubricating system is working.
When necessary, replace the oil with chain bar oil from your local Bunnings
Warehouse Power Gardening Department.
Cord Retainer
When attaching an extension cord to the chainsaw, hook the end of the extension
cord into the cord retainer (12) located below the rear handle (1). Using the cord
retainer (12) prevents accidental disconnection of the chainsaw and extension
cord’s plug and socket.
Always be sure to route the power and extension cord away from the work area to
prevent it from coming into contact with the chainsaw when in operation.
Switching On and Off
When switching the chainsaw on, the hand guard/chain brake (5) must be in the
disengaged position (pull it towards you). To switch the chainsaw on, grasp the
front handle (4) with your left hand. With the thumb of your right hand, push the
lock-off switch (3) forward. Whilst holding the lock-off switch (3) in the forward
position, squeeze the on/off switch (2) and release the lock-off switch (3).
To switch the chainsaw off, release the on/off switch (2), the chain (6) will stop
rotating immediately but the chainsaw's motor will continue to make a noise whilst
the chainsaw is running down, this is normal and has no ill effect on the function or
life of the chainsaw.
Running in the Chain
Prior to operation, a new chain should be run in for 2-3 minutes and then its
tension should be checked and adjusted as detailed in the Fitting the Bar Guide
and Chain section.
Fig. 7
