13
MAINTENANCE
Cleaning
Warning:
Do not pour or spray water directly into or over the motor cover.
IMPORTANT:
Never put any of your body parts (including hands) inside the drum
while it is rotating.
IMPORTANT:
Wipe off any external material on the motor cover. Do not use
petrol, turpentine, lacquer, paint thinner, dry cleaning fluids or similar products.
The use of chemical products or solvents may damage the motor cover.
Thoroughly clean your cement mixer at the end of each days operation.
Keep your cement mixer clean. The slightest trace of material left in the drum
assembly (1) will harden and attract more material each time the machine is used.
Dried cement should be scraped out of the drum assembly (1).
DO NOT throw bricks into the drum assembly (1) to clean it out.
DO NOT beat on the drum with a shovel, hammer or other tools to break up
accumulation of dried cement mix as the cement mixer may be damaged.
The drum may be scoured for approximately 2 minutes, using a 1” stone and
water mixture. After this, discharge the stone/water mixture and hose down the
drum assembly (1) inside and out.
The IP44 protection clad construction of the mixer enables the DRUM ASSEMBLY
ONLY to be hosed down safely. Avoid getting water on the motor and motor
housing (8), DO NOT wet the motor and motor housing (8).
General Maintenance
1. Ensure that the power is disconnected from the tool prior to any maintenance
being carried out.
2. Ball bearings are packed with grease at the factory. No further lubrication of
bearings is required.
3. During normal use, painted surfaces can lose their coating during the mixing
process. Wipe all exposed surfaces regularly with an oily rag to prevent
corrosion.
(Note:
Loss of paint and rust are not covered under warranty.)
4. Keep air vents clean of dust and dirt.
5. Remove dust and dirt from the cement mixer regularly with soft cloth, brush or
compressed air. Use a mild detergent and a soft cloth to clean plastic parts.
6. If the power cord is damaged, have it replaced by an electrician or a
power tool repairer.
7. Regularly check that all bolts, screws and nuts are securely fixed as these
could work loose during normal operation.
Note:
Ozito Industries will not be responsible for any damage or injuries caused
by the repair of the tool by an unauthorised person or by mishandling of the tool.
Содержание CMX-080
Страница 1: ......
