ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
1. Material Support Bars
2. Material Clamp
3. Rear Fence
4. Retractable Safety Guard
5. Rotating Mitre Table
6. Bevel Indicator Scale
7. Mitre Lock Handle
8. Head Locking Pin
9. Spindle Lock Button
10. On/Off Switch
11. Carbon Brush Cap
12. Operating Handle
MITRE SAW
KNOW YOUR PRODUCT
1. ASSEMBLY
3. Unfold the rear stabilising
bar from the underside of the
saw and lock into position
as shown if using saw free
standing.
1. Fits over the dust
extraction port.
1. Can be mounted to the
fence, either the left or right
hand side.
2. Tighten screw on fence to
secure in place
1. Insert material support
bars into the two holes
located on both sides of
the base.
2. Tighten screw on base
to secure in place
Release cutting head from its transport position.
SETUP & PREPARATION
Material Support Bars
Dust Bag
Material Clamp
Release
2
2. Insert mitre lock handle
and tighten.
1. While holding the head of the saw down release the lock down
knob.
13. Hex Key
14. Dust Bag
