PREPARATION AND SET-UP (cont.)
9
Important Charging Notes
1. The charger adaptor (10) and battery (5) may become warm to touch while
charging. This is a normal condition, and does not indicate a problem.
2. Use the charger at normal room temperature whenever possible. To prevent
overheating, do not cover the charger and do not charge the battery pack in
direct sunlight or near heat sources.
3. If the battery (5) does not charge properly:
- Check current at mains power outlet by plugging in a lamp or other appliance.
- If charging problems persist, have the complete tool checked by an electrician
or a power tool repairer.
Installing the Battery
1. Insert the battery (5) into the battery recess on the
drill until it clicks into place (Fig. 3).
2. Do not use excessive force when inserting the bat-
tery (5). If the battery (5) does not slide in easily, it is
not being inserted correctly and could cause dam-
age to the battery (5), battery terminals or the drill.
Caution:
Do not operate the variable speed trigger (8)
whilst inserting the battery.
Removing the Battery
1. Depress the battery release button (6) and remove the battery (5).
Getting Started
It is important to understand the functions of the various controls. Please see below
how and when to use the variable speed switch, forward/reverse control and torque
control.
Familiarize yourself with these controls before first use of your new drill.
Variable Speed Trigger
The variable speed trigger (8) allows you operate the drill
at different speed. The speed depends on the pressure
that you apply on the variable speed trigger (8).
1. Turn the drill ON by depressing the variable speed
trigger (8) (Fig. 4).
2. To turn the drill OFF, release the variable speed
trigger (8).
Fig. 3
Fig. 4
DRILL OPERATION
