Ozito bsr-800, Инструкция по эксплуатации

Страница: 9 / 16

8
PREPARATION & SETUP (cont.)
Removing Sanding Belts
1. Place the belt sander on its left side on a flat surface.
2. Pull out the belt tension release lever (9). Push it
towards the front of the sander until it locks into place.
The front roller retracts, releasing tension on the belt
(Fig. 4).
3. With the belt sander still on its left side, gently slide
the belt off the unit (Fig. 5). Use two hands easing both
sides simultaneously.
Installing Sanding Belts
When installing a belt, ensure you have the correct size for
your belt sander, and correct grit for your workpiece. Belts
have arrows marked on them to assist in fitting them to the
belt sander in the correct direction. Belts are also marked
with a grit rating (Fig. 6).
1. Place the belt sander on its left side on a flat surface.
2. With the belt tension release lever (8) locked, gently
place the belt over the front and rear rollers. The arrows
on the belt are to be aligned with the arrow marked on
the belt sander (Fig. 7).
CAUTION: The arrows on the belt must be aligned with the markings on the belt
sander. Incorrect fitment could cause the belt to break. Belts are not covered by
the warranty
.
3. Once the belt is in place, return the belt tension release lever (8) to its
original position.
Fig. 4
Fig. 5
Fig. 6
Fig. 7